UV Solutions, LLC

V-FLEX UVC and Lamp Assemblies are assembled and tested. They consist of a Housing Power Supply Lamp Socket, Lamp, Mounting Extrusion, Power Module and Extrusion Mounting Bracket and are to be constructed to withstand HVAC environments. Fixtures are UL/C-UL listed under ABQK Classifications and provide for unobstructed 360 degree UVC irradiance from lamp to surfaces and the air stream.

Housing is constructed of stainless steel in a drip proof design that is equipped with mounting tabs to facilitate housing positioning and fastening anywhere on the Mounting Extrusions four sides. Power to each fixture is from UL approved "plug and light" power service from the mounting extrusion raceway. The housing accommodates the lamp socket internally to prevent lamp pin exposure to the air stream. The housing incorporates all components into one integral assembly to maximize lamp serviceability and to allow 360 degree UVC irradiance from the lamp to surfaces and airstream.

Power Supply is a Class 2, rapid start type electronic power supply that includes RF and EMI suppression. Each is supplied with power via a factory supplied Mounting Extrusion Raceway that is equipped with a UL approved and NEC compliant Power Module. The power supply maximizes photon production, radiance and reliability and is UL Listed for cold and / or moving air streams of 55 degrees - 135 degrees F, and 1000 fpm. Power is to be 120 Vac.

Lamp Socket is constructed of UVC resistant, commercial grade HVAC materials designed for long service. They are protected from the air-stream, enclosed in the housing. The Lamp Socket accommodates a Lamp to provide 360 degrees UVC irradiance to surfaces and the air stream.

Lamp is a very high output, wind chill resistant, 60 Watt, T5 diameter, hot cathode, and twin tube bi-axial type equipped with a four pin lamp base that is fully encapsulated when inserted into the Lamp Socket. The Lamp produces no less that 80% of it's initial UVC output at its end of lamp life, or after 9000 hours of service. Each Lamp contains no more than 5.0 milligrams of mercury, to protect the environment and to provide for future EPA environmental compliance. Each Lamp produces its specified output at 500 fpm in temperatures of 55-135 degrees F. The Lamp does not produce ozone, fumes or any other contamination.

Mounting Extrusion is UL Listed and constructed of Bright Anodized, 6463-T5 aluminum extrusion to withstand HVAC environments and to accommodate the fixture Housing on any of its four sides. It is designed with covered Power Raceways to provide A/C power to each Power Supply connected to any of its four sides. The Mounting Extrusion and Power Raceway Covers are able to be field-cut to accommodate most any plenum length.

Power Module is UL Listed and constructed of stainless steel. It is equipped with mounting tabs to facilitate fastening to any of the Mounting Extrusion four sides. The Power Module distributes power to each Mounting Extrusion Raceway in accordance with electrical codes.

Mounting Bracket is constructed of stainless steel and designed to accommodate, hold and fasten the Mounting Extrusion to the plenum base.

Independent Testing: The V-Flex UVC system has been tested to verify specified performance and conformity to UL/C-UL as to Category Code ABQK ( Accessories, Air Duct Mounted) and UL Standards; 153, 1598 & 1995 respectively.